Pilates Footwork on the Reformer: Setup, Positions, Springs
Pilates Footwork on the Reformer: Setup, Positions, Springs

Reformer footwork is the first exercise series of the classical Reformer workout. You lie on the carriage, press your feet into the footbar and glide out and in against the springs, while your pelvis stays level and your ribcage stays down. It warms up the legs, but its real job is to set your alignment from the feet up. This guide covers the setup, each foot position, spring choice, breath, common faults and sensible modifications.
TL;DR
- Footwork is a warm-up and an alignment check in one: press out on the inhale, return slowly on the exhale, and keep your pelvis level throughout.
- The classic sequence is Pilates V (small V), Parallel or Bird on a Perch, Heels, then Heel Lowers (Tendon Stretch), about 10 repetitions each.
- Most teachers start with three or four springs, but the right load depends on your body and how well you control the carriage.
- If your lower back arches, your pelvis lifts or you rush the return, the load is usually the problem, not your effort.
- Knee, neck, shoulder or forefoot issues call for modifications, which a well-trained instructor can set up for you.
Table of Contents
- What footwork on the reformer is for
- How to set up and perform footwork
- The foot positions, one by one
- Choosing the right springs
- Breath, alignment and control
- Common mistakes and how to fix them
- Modifications and safety for beginners
- A simple footwork sequence to know
- Our perspective
- Learn footwork with us in downtown Montréal
- FAQ
- Sources
What footwork on the reformer is for
Footwork is where reformer work begins in the traditional system. Pilates Andrea describes four exercises that open the Reformer workout: Toes, Arches, Heels and Tendon Stretch. Everything that follows in a session builds on how you organize yourself here.
Three things are being trained at once:
- Alignment. Your ankles, knees and hips track in one line while the pelvis stays still.
- Control. The springs pull the carriage in, and you decide how fast it moves.
- Warm-up. The legs, feet and trunk wake up before heavier work.
Pilatesology lists the goals of the series as warming up and focusing the mind, lengthening from toes to crown, establishing alignment, and building foot flexibility and strength. That is why it is easy to learn and takes years to do well.
How to set up and perform footwork
Setting up the reformer
- Footbar: raise it to its highest position.
- Headrest: lift it, so your neck is supported and long.
- Springs: start with a moderate load. Sources vary between two and four springs, and we cover how to choose below.
- Position: lie on the carriage with your shoulders resting against the shoulder blocks, arms long by your sides.
For a standard footwork setup, Verywell Fit describes four springs, the headrest up, and 10 repetitions in each foot position, pressing out on the inhale and returning on the exhale.
The movement
Start with a neutral pelvis, open shoulders and engaged abdominals. Place the balls of your feet on the bar in Pilates V. Pilates Anytime’s Amy Havens describes pressing the carriage out by extending the legs while the pelvis stays level and the ribcage stays anchored, then returning with control through the ankles, knees and hips.
A few reference points we use in the studio:
- Extend the legs without locking the knees.
- Keep the carriage moving at the same speed out and in.
- Let the movement come from the hips, knees and ankles, not from the back.
- Stop short of the point where your lower back starts to arch.
The foot positions, one by one
Each position changes which muscles lead and what your instructor can see in your alignment. The classical order moves from a stable base to more specific work.
| Position | Foot placement | What it emphasizes |
|---|---|---|
| Pilates V (small V) | Balls of the feet on the bar, heels together and lifted, toes apart | Turnout from the hips, tracking of the knees over the feet |
| Parallel / Toes | Balls of the feet on the bar, legs parallel | Quadriceps and calves, even loading |
| Arches | Arches of the feet wrapped on the bar | Balanced work through the foot, stretch along the top of the foot |
| Heels | Heels on the bar, feet flexed, knees parallel | Hamstrings and glutes |
| Heel Lowers / Tendon Stretch | Balls of the feet on the bar, heels drop and lift | Full ankle range, calf and Achilles tendon |
| Wide second | Wide on the bar, legs turned out | Inner thighs and outer hip |
The muscle emphasis above is consistent with how teaching resources describe it. Reneau Reformers notes that heels on the bar emphasize hamstrings and glutes, wide second position targets adductors and external rotators, and single-leg work doubles the load and exposes asymmetry. Pilates Plans adds a prehensile variation, with the toes wrapped over the bar for articulation of the ankle and foot.
Pilates V
This is the usual opener. The V position raises the heels while the legs stay externally rotated, so the knees sit over the feet and the hips are open. Watch for knees drifting inward when you press.
Heels
The feet are fully flexed, as if pushing against a wall, with the knees parallel. This shifts the work to the back of the legs and is a good check on whether your pelvis stays steady.
Heel Lowers (Lower and Lift)
Only the ankles move. Your knees, pelvis and lower back stay fixed. Go slowly: if you speed through the drop, you stop feeling the ankle’s range.
Single leg
Once the two-leg series feels steady, single-leg work reveals differences between sides. It builds unilateral strength, hip stability and trunk control, and it asks that your pelvis stay level without hiking or shifting.
Choosing the right springs
There is no single correct number. Peak Pilates recommends three to four springs for footwork and notes that taller people feel more resistance at the end of the range. Polestar Pilates suggests two to three springs for most beginners on a standard reformer. Those two ranges overlap, which tells you that the choice is personal.
Here is a practical way to read your own setup:
- Too light: the carriage feels out of control, and the springs snap it back before you can resist. HFE Pilates describes that feeling as a sign the tension is too light.
- Too heavy: the movement feels constricted or compressed.
- A pelvis that lifts, a back that arches or shoulders that creep up: Polestar points out that most compensation is a loading problem rather than a cueing problem, so a lighter or heavier setting may help more than another correction.
If you want to understand how trainers think about adjusting resistance for people with joint conditions, this guide to arthritis exercise modifications covers the same principle: change the load and range to fit the person.
In our classes, your instructor sets and adjusts the springs for your body, and the classes are capped at 12 people on the Reformer so that adjustment actually happens.

Breath, alignment and control
The usual pattern is to press out on the inhale and return on the exhale. Some variations reverse the breath later in your practice, but start with the standard pattern until the movement is stable.
Amy Havens calls footwork the grounding place to begin all reformer work, and her phrase “resist the springs” means pressing slowly and pulling in slowly instead of letting the springs close the carriage.
Three cues we return to again and again:
- Level pelvis. Imagine a glass of water resting on your hip bones.
- Heavy ribcage. Your ribs stay down instead of flaring as the legs extend.
- Even speed. The return takes as long as the press.
Common mistakes and how to fix them
Pilates Addicts’ teaching notes list the faults teachers see most often. Here they are with a practical correction for each.
| Fault | What to try |
|---|---|
| Gripping or curling the toes | Spread the toes gently and press through the ball of the foot |
| Knees drifting in or out | Line the kneecap up with the second toe, and reduce the range if needed |
| Hiking the pelvis in single-leg work | Reduce the load and let the pelvis stay level before you extend |
| Arching the lower back at end range | Shorten the range and keep the ribs down |
| Locking the knees | Stop just short of full extension |
| Rushing the return | Count the return and take the same time as the press |
The Heel Lowers deserve their own note. Fortus Pilates suggests a slow count of three on the way down and three on the way back, and notes that returning the carriage to the start between repetitions is a useful modification.
Modifications and safety for beginners
Footwork is a beginner exercise, and it is also one that needs to fit you. A teacher’s course manual from Peak Performance Pilates lists the situations that call for adjustments: knee problems, neck or shoulder tension under resistance, and forefoot (metatarsal) injuries. Its suggested modifications include:
- A block in the track, or the low bar setting, to reduce knee bend for tall clients or knee patients.
- Two or one springs if three place too much pressure on the legs, shoulders or neck.
- A jump board, or footwork on the heels, if the metatarsals hurt.
If you have a knee, hip or spine condition, or you are recovering from surgery, work through the setup with your physiotherapist’s guidance and tell your instructor before you begin. Many of the people who come to us are referred by their physiotherapists, and private sessions let us adapt the springs, range and foot position to what your physiotherapist has recommended. You can read more on Pilates for rehabilitation in Montréal.
A simple footwork sequence to know
When you take a class, expect something like this, at about 10 repetitions per position:
- Pilates V
- Parallel or Bird on a Perch
- Arches
- Heels
- Heel Lowers
- Single leg, once the two-leg work is stable
Treat the numbers as a guide. A beginner may do fewer repetitions with better quality, and a practitioner of many years may use the series to refine tiny details of tracking.
Our perspective
Footwork is the exercise people want to skip, and it is the one I would never skip. In the first minutes on the reformer, I can see how someone stands, how their pelvis moves, where they grip and how they use their feet.
At MTLPILATES we teach the full Pilates system, not only the Reformer. Footwork on the Reformer connects to what you do on the Wunda Chair, the Barrel and the Cadillac, because the same principles of alignment and control run through all of it. That is how Joseph Pilates intended the work to be learned, one block at a time.
It is also why therapeutic work is our strength. When a physiotherapist or doctor sends someone to us after an injury or surgery, footwork is often where we start. The load is small, the position is supported and we can see exactly what the body is doing. Small, supervised classes and private sessions let us correct by hand and adjust the springs for you.
Pilates is for every body type, at any age. Begin with the basics and let them get better for years.
Véronique Lefort
Learn footwork with us in downtown Montréal
Footwork is easiest to learn with someone adjusting your springs and your alignment in real time. Our Reformer classes are capped at 12 people and run 50 minutes, and every instructor is certified across the full system. The Reformer Foundations class is a clear starting point, and group classes are $33 each. You can see all levels on our group class page.

If you want one-on-one attention, for example after an injury or surgery, private sessions are $100 to $130 and duo sessions are $120 per session. Details are on the private and duo sessions page, and you can read about the Reformer in Montréal before you book. Classes are taught in English and French.
FAQ
How many springs should I use for reformer footwork?
Most sources suggest two to four springs, and the right number depends on your body and control. Peak Pilates recommends three to four springs, while Polestar suggests two to three for most beginners. Your instructor adjusts the load until you can move at an even speed with a level pelvis.
Is footwork a good exercise for beginners?
Yes. It is one of the first exercises taught because the position is supported and the movement is simple. It also teaches the alignment you use in the rest of the Reformer work. Our beginner articles explain what to expect in your first weeks.
Why does my lower back arch during footwork?
Usually the load or the range is too much for your current control. Shortening the range, keeping the ribs down and adjusting the springs often help. Polestar notes that a back that arches under load is a sign the springs are creating more demand than you can manage.
Can I do footwork with a knee problem?
Often yes, with modifications such as a lighter spring setting or reduced knee bend, as listed in a teacher training manual. Check with your physiotherapist first and tell your instructor before the session starts.
Sources
- Pilates Reformer Exercises for Beginners, Verywell Fit
- Footwork with Amy Havens, Pilates Anytime
- Footwork Series, Pilatesology
- Revisiting the Basics: Footwork on the Reformer, Pilates Andrea
- Reformer Footwork: Getting It Right, Reneau Reformers
- 14 Reformer Footwork Variations, Pilates Plans
- Footwork on the Reformer, Lighter Living
- Reformer Spring Resistance: The Basics, Peak Pilates
- Reformer Spring Logic, Polestar Pilates
- Reformer Springs: The Role of Resistance in Pilates, HFE
- Footwork: Teaching Notes, Pilates Addicts
- Footwork: Lower and Lift, Fortus Pilates
- Reformer manual, Footwork, Peak Performance Pilates
- Arthritis Exercise Modifications